(, 08:30 PM) saabdoctor Wrote: when i run the crack on vag com 409.1 it says its activated but when i try to actually use vag com it says its not activated- any ideas? Tried a few times, same result. 4) Once you install the 64 bit driver, you can plug in your cable and you should be able to see it in Windows 'Device Manager'. Configure it for COM1 - COM4 per the instructions on the mini-CD. 5) VAG COM 409.1, which is an older but not crippled version of the VAG COM software, does not work under normal circumstances with Windows 7 64-bit.

Poliglot kul'tura torrent skachat'. Opornye konspekty po russkomu yazyku marchenko skachat'. Skachat' audiokurs nemeckogo yazyka dlya prodolzhayuschih,. A> russkogo-yazyka. Konspekti po poliglotu nemeckogo yazika.

• Uncompress the file. Double-click on 'Install.exe' to install the drivers. • Plug cable into any computer's USB port. • 'Found New Hardware Wizard' will start and it will ask you 'Can Windows connect to Windows Update to search for the software?' Select 'Yes'. • Select 'Install the software automatically'.

• After the installation is complete, click 'Finish'. • 'Found New Hardware Wizard' will start once again because there are two drivers for this cable. • Go through the same steps as explained above to install this second driver. If install is successful, move onto Step 2. If installation fails, see below: Troubleshooting: If Drivers Failed To Install. Installation failed?. Unextract the file into any folder.

Then while your cable is connected to the computer — go Device Manager. • Windows Vista/7/8/10: Control Panel » System » Device Manager • Windows XP: Control Panel » System » 'Hardware' tab » Device Manager You'll see a device similar to 'USB Serial Port' under either 'Other devices' or 'Ports (COM & LPT)'.

Right-click and choose 'Update Driver Software'. Like this: Then select the location where you unextracted Driver Pack 2. Let it install. STEP 2: Discover Port Number that VAG-COM KKL Cable is Using Go to Control Panel. • Windows Vista/7/8/10: Control Panel » System » Device Manager • Windows XP: Control Panel » System » 'Hardware' tab » Device Manager Expand 'Other devices' or 'Ports (COM & LPT)'.

Whichever contains 'USB Serial Port'. Next to 'USB Serial Port' — you'll see a number. If the COM port number is between 1-4, then everything is fine. Move onto Step 3. If the COM port number is above 4, then we'll have to change it so it's between 1-4.

Right-click on 'USB Serial Port' and click on 'Properties' — as per below pic: Then: • Click: Port Settings • Click: Advanced • For 'COM Port Number' — you MUST choose any number between 1-4. Now let's test if everything is working. Move onto next step below.

STEP 3: Test Everything is Working Cable should be plugged into computer. • Start VCDS-Lite software.

• Click 'Options' button. • You will see 'Select COM Port' box. Select the 'COM Port' number as explained in Step 2. • Click the ‘Test’ button.

• If everything is good, it should display 'Interface Status: Found!' • You can now connect other end of cable to car. Turn on ignition. And you're ready to start diagnosing! If test is not successful — check the following: • Other software or devices using USB ports or that same COM Port could be conflicting. You should uninstall the suspected software or device for troubleshooting this problem.